ARNOTT
More Information for ARNOTT P2291
{Alternate Inventory Numbers: P-2291}
Continue Shopping
 
ARNOTT P2291  
$565.79
Price
$0.00
Core
+ Sold in packs of 1x1
Pack
$565.79
Total
ARNOTT P2291close
<
>
Part image
ARNOTT P2291 Specifications
Air Fitting Size0.17mm
Air Spring System TypeElectric
Dryer IncludedYes
Full Load Amperage27
Maximum Pressure180 psi
Mounting Bracket IncludedNo
OESYes
Protective Cover IncludedYes
Wiring Harness IncludedNo
Working Pressure170 psi
Includes Dryer
Arnott's air compressor is a new genuine OE part. These complete OEM air compressor units were purchased as an overstock item and are completely assembled and ready to bolt in. This new compressor unit comes complete with air fittings and new vibration spring isolators. Arnott backs these new units with a Limited Two-Year Warranty.

Installation Video

Installation Information

Air Compressor failure is typically the result of a leak or other issue in the air suspension system. To ensure that your new compressor will work without issue, you should do the following, prior to installation:

  • Check for blown fuses and ensure the relay is working properly. A failed Air Suspension Compressor Relay is a top cause of air compressor failure. They normally fail in the “closed” position and should be replaced during compressor installation
  • Check and replace the Air Springs if they are showing signs of cracks, deterioration, moisture, or are leaking. Complete Air Strut assemblies, which include the Mount and Air Spring, can be found in the Strut category
  • Verify that the air line and wiring harnesses are connected without signs of physical damage
  • Ensure that the fittings and valve connections are fully seated and undamaged. Make sure that the air line is secured at the proper depth
  • Check the electrical connections and the orientation of the Ride Height Sensor arms
  • Check all Air Suspension Solenoid connections and fittings; inspect for any cracks or other damage
  • Inspect the air lines for kinks, holes or other damage


Looking To Convert Your Air Suspension To a Coil Over Suspension?

If you like the load-leveling capabilities, or if you tow with your vehicle, then you should repair the original air suspension system.

If not, and you are tired of the high cost of replacing air suspension components, conversion components can be found for most vehicles under the Coil Spring, Strut / Coil Spring / Mount Assembly and/or Suspension Conversion Kit categories, in the RockAuto catalog, depending on the vehicle setup.

Additional Resources

Installation Instructions
OEM / Interchange Numbers: C2C22825, C2C2450, C2C27702, C2C27702E

ARNOTT Warranty Information:
Parts purchased before 7/1/2023 - Limited Lifetime. Parts purchased on or after 7/1/2023 - 24 Months.
Warranty Details