|
ATE 425176
|
|
$78.79
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$78.79
Total
|
|
|
(Only 1 Remaining)
|
|
|
| Image is of a typical part(s); part appearance varies by application. Rotors & Drums are sold individually |
| ATE 425176 Specifications |
|---|
| ABS Sensor Ring Included | No | | Bearings Included | No | | Bolt Hole Quantity | 5 | | Construction | Full Cast | | Disc Finish | Non-Directional | | Discard Thickness (MM) | 22.00 | | Height (MM) | 91.50 | | Inside Diameter (MM) | 161.10 | | Nominal Thickness (MM) | 25.00 | | Outside Diameter (MM) | 297.50 | | Rust Resistant Coating | Yes | | Solid Or Vented Type Rotor | Vented | | Surface Type | Smooth |
|
|
Qualities and Advantages of ATE Original Brake Rotors
- Thermal conductivity – high-carbon (HC) brake discs prevent judder and reduce wear
- Heat compensating groove regulates temperature flux in friction ring surfaces
- Problem free run in of brakes owing to reduced surface roughness
- Optimum braking performance – only state-of-the-art OE materials are used
- Alloyed brake discs – less wear and less susceptibility to noise
- Smallest tolerances for "run-out" and "DTV" – no erosion, no judder
- No steering wheel wobble – simply drive off with balanced brake disc
 Installation Tips - Always replace Brake Pads and inspect Calipers and Brake Hoses when installing new rotors
- Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
- After removing the old rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
- Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
- Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
- Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
- After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function
|
| OEM / Interchange Numbers: ANR4582, SDB000380 |
ATE Warranty Information:12 Months |
|
