|
NUGEON 97P17243B
|
|
$18.62
Price
|
$10.00
Core
|
+ Sold in packs of 1x1
Pack
|
$28.62
Total
|
|
|
|
|
|
| NUGEON 97P17243B Specifications |
|---|
| Anti-Squeal Shims Included | No | | Bleeder Screw Cap Included | No | | Bleeder Screw Included | Yes | | Bleeder Screw Thread (MM) | M10-1.5 x 29.5 | | Bleeder Thread Size | M10-1.5 | | Bracket Included | No | | Bracket Mounting Bolts Included | No | | Caliper And Pad Hardware Included | No | | Caliper Casting Material | Cast Iron | | Caliper Color | Gray | | Caliper Finish | Rust Preventative | | Dust Boots Included | Yes | | Hardware Included | Yes | | Housing Cast Numbers | 18007152, L, 18007947 | | Inlet Fitting Type | Banjo Bolt | | Inlet Port Thread Size (MM) | M10-1.5 x 23.14 | | Inlet Thread Size | M10-1.5 | | New Or Remanufactured | Remanufactured | | Pads Included | No | | Piston 1 Outside Diameter (in) | 3 | | Piston 1 Outside Diameter (mm) | 75 | | Piston Material | Steel | | Piston Quantity | 1 | | Wear Sensors Included | No |
|
|
Every NuGeon Techshield 360°™ caliper is remanufactured under the highest quality standards to meet or exceed the specifications required by the original design, and tested during the assembly process for leaks, free moving pistons, and smooth bracket sliding. TechShield 360™ is a proprietary electrodeposition coating applied to brake calipers via an automated submersion process.
Features & Benefits:
- The electrodeposition coating is applied via submersion, and not a spray, offering more consistent and uniform coverage of both the housing and the bracket (where included)
- The electrodeposition coating passes a 96-hour continuous salt spray validation test
- The coating is environmentally friendly, heavy metal-free, and OSHA and EPA compliant
- Every caliper is pressure tested to ensure brakes perform at optimum level
- New bleeder screws provide trouble-free bleeding and an air-tight seal
- Pre-lubricated guide bolts on mounting brackets save installation time and prevent seizing
- 100% S.A.E. specific rubber seals ensure like-new performance
- Banjo bolts, copper crush washers and parking brake cable brackets, levers and return springs all preinstalled for easy installation
 Installation Tips - Always inspect brake pads and rotors when replacing your calipers. Faulty calipers can lead to uneven pad and rotor wear
- Inspect or change brake hoses when replacing the caliper. Worn or damaged hoses should be replaced to prevent brake fluid contamination or loss
- Use a Brake Fluid Tester to test your brake fluid. If your brake fluid has moisture in it, flush the system before installing the new caliper
- Apply Blue Threadlocker to caliper bracket mounting bolts to lock the bolts in place and prevent loosening or backing out
- After installing the new caliper, bleed your brakes to ensure no air is trapped in the brake fluid. RockAuto offers a selection of Brake Bleeding Tools to help with this process
- After the brakes have been bled, top off the master cylinder reservoir with the proper Brake Fluid
Attention California Customers - WARNING: Cancer and Reproductive Harm
Attention California Customers - Y
|
NUGEON Warranty Information:Limited Lifetime |
|
